|
Auto By-Pass Unit
As the industry & telecom department
is using multi source of supply
and use a single suitable supply
as their requirement by using
change over switch. Increasing
or decreasing the AC voltage on
input distribution panel the
efficiency goes very low about
60 to 65%. Due to this
efficiency loss most of raw power
goes waste as heat & lot of
revenue loss to telecom
department. When high voltage or
low voltage crosses the voltage
limit and attached equipment
gets faulty. To overcome this
type of problem we introduce our
product Auto By-Pass.
Operation
SMPS rectifiers can work between
150V to 275V on single phase &
320 to 480V in three phases.
Auto-By-Pass will by pass the
auxiliary supply whenever mains
will be available in between the
range. If mains will go out of
this range, at that time this
unit will connect with Auxiliary
source automatically. By using
the Auto-By-Pass system,
Auxiliary source will come in
picture as less as possible, too
over come lot of power loss as
well as revenue loss.
Features
LED indication for Normal
Voltage, High Voltage and Low
Voltage, By Pass On.
Product range
ABP is available for single &
three phase system in current
range of 60, 80,100A for single
phase & 60, 80,100,130A/Phase
for three phase system to meet
telecom department requirement.
Installation
ABP will be installed across the
stabilizer or can be installed
as a protection device against
high voltage/low voltage at the
input side of rectifier.
Installation manual will be
provided along with system.
|
